Dynapac CS1400, Instruction Manual

Page: 89 / 118

Maintenance - 50h
4812162501_F.pdf 2018-04-25
Air cleaner
- Cleaning
Wipe clean the inside of the cover (2) and the filter
housing (5). See the previous illustration.
Wipe clean on both sides of the outlet
pipe.
Outer edge of outlet
pipe. Inner edge of
outlet pipe.
Wipe also both surfaces for the outlet pipe; see
adjacent figure.
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine. Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.
Articulation steering and steering cylinder
bushings - Lubrication
Fig. Lubricant nipples
1. Lubricant nipples, articulation
2. Bearings, steering cylinder
1
2
2
1
1
Nobody must be allowed near the steering joint
when the engine is running. Danger of being
crushed when steering is operated. Push the
reserve/parking brake knob before lubricating. Nobody must be allowed near the steering joint
when the engine is running. Danger of being
crushed when steering is operated. Push the
reserve/parking brake knob before lubricating.
Turn the steering wheel fully to gain access to all
seven grease nipples (1 and 2) from the right side of
the machine.
Wipe the grease nipples. Lubricate the articulation
nipples (1) with five strokes of the hand grease gun,
and the steering cylinder bearings (2) with three
strokes in each bearing. Make sure that grease
penetrates the bearings. If grease does not penetrate
the bearings, it may be necessary to relieve the
articulation joint with a jack while repeating the
greasing process.
79