Dynapac CS1400, Instruction Manual

Page: 113 / 118

Maintenance - 2000h
4812162501_F.pdf 2018-04-25
Hydraulic reservoir - Changing the fluid
Danger of being burned when draining hot oil.
Protect your hands. Danger of being burned when draining hot oil.
Protect your hands.
Fig. Hydraulic reservoir
1. Drain plug
2. Filler cap
3. Strainer
1
2, 3
Place a receptacle that will hold at least 50 liters
under the drain plug. Save the oil and dispose of
it in an approved manner. Place a receptacle that will hold at least 50 liters
under the drain plug. Save the oil and dispose of
it in an approved manner.
Remove the drain plug (1) and allow all the oil to run
out, wipe and refit the drain plug.
Wash the filler cap (3) and the strainer (4) using a
cleaning agent and blow them dry.
Fill with fresh hydraulic fluid of the grade indicated
in the Lubricant specification. Fill with fresh hydraulic fluid of the grade indicated
in the Lubricant specification.
Replace the hydraulic filter as described under the
heading "Every 1000 hours of operation."
Start the engine and operate the various hydraulic
functions. Check the level in the reservoir and top off
as required.
Fuel tank - Cleaning
Fig. Fuel tank
1. Drain plug
1
It is easiest to clean the tank when it is almost empty.
Place a receptacle that will hold at least 50 liters
under the drain plug. Save the fuel and dispose of
it properly. Place a receptacle that will hold at least 50 liters
under the drain plug. Save the fuel and dispose of
it properly.
Remove the drain plug (1) and allow all the fuel to run
out. To get rid of more of the silt you can fill the tank
with two liters of diesel and let it run through the tank.
Wipe and put back the drain plug.
Keep in mind fire risk when handling fuel. Keep in mind fire risk when handling fuel.
103