Dynapac CA250 i, Instruction Manual

Page: 70 / 93

Maintenance, 10h
ICA250i-IN2EN1.pdf 2012-12-19
Brakes - Check
Check operation of the brakes as follows: Check operation of the brakes as follows:
Checking the parking brake
Fig. Instrument panel
1. Parkering brake switch
2. Parkering brake lamp
1
2
Drive the roller slowly forward. Hold the steering wheel
firmly and brace yourself for a sudden stop.
Push in the parking brake switch (1). The roller should
stop immediately with the engine running.
After testing the brakes, set the forward/reverse lever
in neutral.
Reset the parkering brake switch (1).
The roller is now ready for operation.
Refer also to the section in the manual on operation.
Hydraulic reservoir - Check fluid level
Fig. Sight glass hydraulic reservoir
1. Sight glass
1
The sight glass is located on the right-hand side of the
roller behind the operator's seat.
Place the roller on a flat surface and check the fluid
level in the sight glass (1). If the level is too low, top up
with the type of hydraulic fluid specified in the lubricant
specification.
62