Dynapac CA250 i, Instruction Manual

Page: 85 / 93

Maintenance - 1000h
ICA250i-IN2EN1.pdf 2012-12-19
Fuel tank - Drainage
1
Fig. Fuel tank
1. Drainage plug
Water and sediment in the fuel tank are removed via
the drainage plug (1) in the bottom of the fuel tank.
Be very careful during draining. Do not drop the
plug or else all the fuel will flow out. Be very careful during draining. Do not drop the
plug or else all the fuel will flow out.
Drainage must be performed when the roller has been
stationary for an extended period, e.g. after being
stationary overnight. The fuel level should be as low
as possible.
The roller should preferably have been standing with
this side slightly lower, so that water and sediment
have gathered near the drainage plug (1).
Save the condensate and sediment and hand it in
to an environment-friendly waste disposal station. Save the condensate and sediment and hand it in
to an environment-friendly waste disposal station.
Drain as
follows:
- Place a container under the plug (1).
- Remove the plug (1).
- Drain out the condensate and sediment until only
pure fuel emerges at the plug.
- Screw in the plug again.
77