GBK60027 DX-SLM Installation Manual Issue 5
10
Safety and Misuse Warnings
All warnings throughout this Installation Manual must be read and understood. If in
doubt ask for advice.
This DX component must not be used other than in the manner described in this
Installation Manual.
The completed installation must be thoroughly checked, and all programmable
options must be correctly adjusted for safe operation prior to use.
Pass on to user:
A warning must be conveyed to the wheelchair user that the controller could
cause the chair to come to a sudden stop. In situations where this may affect the
safety of the user, this will require the fitting and wearing of a seat belt.
The DX control system is fully programmable to optimise performance and safety.
Do not operate the wheelchair unless you have full control. Ensure that the chair is
correctly programmed for your needs and environment and ask your dealer to
adjust if necessary. Always choose a Drive Program that you feel safe with and
that is compatible with your environment.
Do not operate the DX System if it behaves erratically, or shows abnormal heating,
smoke or arcing. Turn the system off, disconnect the battery or open the battery
overload switch, and consult your Service Agent.
Do not operate the DX System if the battery is nearly flat as a dangerous situation
may result due to loss of power in an inopportune place.
Ensure the controller is turned off when not in use.
No connector pins should be touched, as contamination or damage due to
electrostatic discharge may result. Dummy sockets in unused DX BUS connectors
should be left in place unless a new module is added to the system.
Report any malfunctions immediately to your Service Agent.
Page 48
M
T
