GBK60027 DX-SLM Installation Manual Issue 5
7.2
DX Remote Wizard Parameters
Key:
Editable at this level (see section 7.1.2.1 of the DX System manual)
Viewable at this level
Note:
Refer to the Wizard User Manual and the DX System Manual for detailed
operating instructions.
Parameters related to the SLM contained in the DX Remote program fall into two
categories:
1.
Lighting Parameters and
2.
Drive Program parameters.
7.2.1
Lighting Parameters
The lighting parameters must be enabled so that lights will operate.
7.2.1.1
Side Lights Enable
Parameter
Possible Values Default
HHP Lite Std Adv
Side Lights Enable
Yes/No
Yes
-
If set to ‘yes’, sidelights (front and rear) are enabled. If set to ‘no’, there will be no
response to a DX Remote sidelight button being pressed (other than a beep for some
varieties of remotes).
7.2.1.2
Indicators Enable
Parameter
Possible Values Default
HHP Lite Std Adv
Indicators Enable
Yes/No
Yes
-
If set to ‘yes’, indicators are enabled. If set to ‘no’, there will be no response to a DX
Remote indicator button being pressed (other than a beep for some varieties of
remotes).
7.2.1.3
Hazard Lights Enable
Parameter
Possible Values Default
HHP Lite Std Adv
Hazard Lights Enable
Yes/No
Yes
-
If set to ‘yes’, hazard lights are enabled. If set to ‘no’, there will be no response to a
DX Remote hazard light button being pressed (other than a beep for some varieties
of remotes).
Page 26
M
T
