GBK60027 DX-SLM Installation Manual Issue 5
5.4.4
Power Supply from the Battery
When the servomotor and lighting require more current than the 12 A DX BUS has
available, the SLM must be powered directly from the battery, and both battery
negative terminals on the SLM must be used.
Note:
1.
Heavy lines denote 3 mm² or heavier wire. All other wires from the 21-way
connector are as specified in section 5.4.2.
2.
Refer to the relevant DX/DX2 Power Module Installation Manual.
Thermal circuit breakers must be installed in the battery wiring to protect the batteries,
wiring loom, and SLM from external short circuits. If the two batteries are permanently
Page 19
M
T
