SapIP – IRT Instruction Manual 1/23/2017
Page 23
Dynamax, Inc.
-
Lastly, to power on the IRT one will need a very small flat-head screwdriver. Place the wire with the
open lead end into the connector housing. Screw down the affixing screw and so the wire will be held
firmly by the screw into the housing.
-
This will cause a closed circuit to the battery and the IRT will power on.
-
Tuck the power switch housing into the cavity and secure with a putty to prevent ants from invading
your power switch housing.
o
Note: LEDs will blink if the unit is turned on, illustrated by the
red arrow
below.
o
The upper side next to the antenna is the Radio power LED. It initially blinks four times when in
contact with the coordinator. After normal operation, the transmit LED will blink briefly only
once each minute. When transmitting the radio LED will blink on for 1/2 second.
o
The lower side LED is the IRT processor and will blink every 10 seconds while taking readings.
o
The lower LED will also blink with signals to the user while transmitting.