SapIP – IRT Instruction Manual 1/23/2017
Page 16
Dynamax, Inc.
2.
Hurricane Pole Attached to Fence Post
-
The second method of successfully installing a SapIP-IRT unit in the field is by mounting the sensor on
a hurricane pole that is vertical or attached to a fence post. Each set of equipment and the procedure(s)
for its installation are described within its associated sub-section below.
2.1
Materials
-
When purchased, the SapIP-IRT comes with all the materials that will be required to mount it on a
medium within the field. For this instance, the customer will need to have a stable fence post firmly
set in the ground with the ability for a vertical pole to be fastened to it. The IRT will be mounted to
the top of this pole where it will take its measurements. Each accessory that is needed during the
installation process can be found below.
2.1.1
Dynamax SapIP-IRT
-
Dynamax SapIP-IRT
-
2” EPS conduit hanger (shown below) which will be needed in order to fasten the unit to
the mount pole.
-
¼ x 1 - 1/2” Hex-Head Bolt SS ; ¼- Hex-Nut SS; ¼ USS Flat Washer SS
-
5/16 x 3” Hex head Bolt Galv.; 5/16 Hex nut Galv; 5/16 Flat Washer
-
Zip-ties (optional)
o
Can be used to fasten any loose cables to the sensor cross-arm.
2.1.2
High-Gain Antenna Kit
-
The high-gain antenna kit is used for applications where long-distance transmission is
required.
o
Note: If the client has purchased a low-gain antenna, refer to its specific installation
technique found within the section above.
-
Each material found in the High-Gain Antenna Kit can be found on the quote provided by
Dynamax during the time of purchase. An illustration of each piece of equipment is
provided below.