DVTEL CT-5322F, User And Installation Manual

Page: 25 / 88

Camera Installation and Mounting
11
23. Close the rear cover over the assembled connector panel by aligning the notch on the cover with
the notch in the camera body. If necessary, reinsert excess cable into the body of the camera.
Figure 17: Covering the Connector Panel
24. Attach the back cover to the camera. Screws are pre-installed in the back cover.
25. Tighten the two fasteners to approximately 8 in-lbs. (0.904 newton meters) of torque.
26. Assemble the two rubber stem bumpers onto the two detents in the concave surface of the solar
shroud.
Figure 18: Solar Shroud and Stem Bumpers
27. Snap the solar shroud over the camera body. The camera is ready for mounting.
Figure 19: Fully Assembled Camera
3.5 Mounting the Camera
The camera can be mounted on a tripod or on a base mount or four-hole bracket.

For tripod mounting, use the tripod adapter, which is available as an accessory.

For base mounting, install the camera base mount on a standard flat side bracket (not provided)
using the supplied #6 32 x 5/8” screws.
See the Appendix (page 62) for a full list of mounting accessories.