CT-5322F/CT-5642F User and Installation Guide
8
To prepare the camera cabling
1.
Disconnect power from any previously installed cables.
2.
Remove the cordgrip parts from the package.
Figure 7: Cordgrip Parts
3.
Feed the wires through the locking nut, then through the camera body and out of the opening on
connector panel.
Figure 8: Cables Inserted through Locking Nut
4.
Feed the wires through the cordgrip body as seen in the picture above.
5.
Place the orange O-ring over the cordgrip and feed the wires through the cordgrip body and sealing
nut as seen in Figure 10.
6.
Insert the Ethernet cable through the center opening of the rubber grommet. Then insert the other
wires through the small holes in the rubber. The wires should be spaced several holes apart.
Nineteen (19) AWG is recommended for the power leads. Twenty (20) AWG is recommended for all
wires other than the Ethernet and video cables. The flat side of the grommet should be on the
inside of the cordgrip.
Figure 9: Rubber Grommet
Figure 10: Wires Inserted through Rubber Grommet
7.
If needed, use a #2 Phillips head screwdriver to widen the hole in the center of the rubber grommet
(Figure 9).
8.
If needed, pierce the smaller holes on the outer perimeter of the rubber grommet for the video
cable, AC/DC supply wiring, audio, alarm, relay, and RS-485 leads.
9.
Measure about 4-1/2” (114mm) of cable from the end of all wires to the rubber grommet.
Summary of Contents for CT-5322F
Page 2: ......
Page 26: ...CT 5322F CT 5642F User and Installation Guide 12...
Page 28: ......
Page 72: ......
