DVTEL CT-5322F, User And Installation Manual

Page: 20 / 88

CT-5322F/CT-5642F User and Installation Guide
6
3 Camera Installation and Mounting
The physical installation of the camera is the first phase of making the unit operational. The goal is to
physically place the unit, connect it to other devices in the system, establish IP network connectivity, and
configure the camera for operation.
Caution:
To avoid damage from overheating or unit failure, assure that there is sufficient temperature
regulation to support the unit’s requirements (cooling/heating). Operating temperature should
be kept in the range specified for the product (-40° to 60°C/-40° to 140°F), with no more than
95% relative humidity, non-condensing).
Attention:
Afin d’éviter tout dommage dû à une surchauffe ou toute panne de l’unité, assurez-vous que la
température est suffisante pour répondre aux temperatur de l’unité
(refroidissement/chauffage). La température de fonctionnement doit être maintenue dans la
plage de température spécifiée pour le produit (-40° à 60°C/-40° à 140°F), sans condensation
d’humidité supérieur à 95%).
3.1 Preparation
Read the instructions in this chapter thoroughly before installing the camera. Following are additional
considerations for outdoor installation:

Always use weatherproof equipment, such as boxes, receptacles, connectors, etc.

For electrical wiring, use the properly rated sheathed cables for conditions to which the cable
will be exposed (for example, moisture, heat, UV, physical requirements, etc.).

Plan ahead to determine where to install infrastructure weatherproof equipment. Whenever
possible, ground components to an outdoor ground.

Use best security practices to design and maintain secured camera access, communications
infrastructure, tamper-proof outdoor boxes, etc.

To minimize the effects of EMI (electromagnetic interference) and RFI (radio frequency
interference), consult your reseller.
3.2 Items Required for Installation That Are Not Supplied
The following items are required for installation, but are not included in the package:

Power source (PoE+ switch, 12-24VDC or 24VAC power supply)

Shielded Twisted Pair (STP) cable if using a PoE+ switch

Cat 5 Ethernet cable for network connection without a PoE+ switch

Tripod or mounting bracket for mounting the camera

One #2 Phillips head screwdriver

One open-end, 1-inch (25.4mm) wrench or adjustable wrench

One 6-inch (152mm) scale or ruler

Electric or manual torque screwdriver set to 10 inch-pounds (1.23 newton meters)

Hex wrench

RJ45 connector

RJ45 crimping tool

Coax cable

Coax cable cutter/stripper

BNC connector