•
When the transfer is completed type
bye
and then press "Enter"
Note:
These steps may vary depending on the FTP client and whether it is on a Linux or
Windows PC. The login information, file names, and destination folder are the same in
both cases.
10.5 Network Restarting
•
To restart networking from the terminal command line do the following:
•
Type:
/etc/init.d/networking restart
and then press "Enter"
10.6 RAID (Partitions)
Two partitions are present in the ShowVault. One partition is “/dev/md0” which is mounted on
“/data” and another partition is ‘/dev/md1” which is mounted on “/opt”. The following sections
explain how to check the health of the RAID (see Section
10.6.1)
and how to reinitialize the
RAID (see Section
10.6.2
).
10.6.1 RAID Failure Identification
•
To check the health of the RAID open a new terminal and login as “root”
•
Type:
more /proc/mdstat
and then press "Enter"
•
On a healthy RAID the command below will appear:
Personalities : [raid5]
md1 : active raid5 sda1[0] sdb1[1] sdc1[2]
21125248 blocks level 5, 64k chunk, algorithm 2 [3/3] [UUU]
md0 : active raid5 sda2[0] sdb2[1] sdc2[2]
760291968 blocks level 5, 64k chunk, algorithm 2 [3/3] [UUU]
•
On a failed RAID the command below will appear:
Personalities : [raid5]
md1 : active raid5 sdb1[1] sdc1[2]
21125248 blocks level 5, 64k chunk, algorithm 2 [3/2] [_UU]
md0 : active raid5 sdb2[1] sdc2[2]
760291968 blocks level 5, 64k chunk, algorithm 2 [3/2] [_UU]
•
In the failed example above, the hard disk drive “/dev/sda” is failed. This failure could be
the result of a hardware failure or it could simply be that the user inadvertently pulled the
drive out.
_____________________________________________________________________________________
SHV.OM.001293.DRM
Page 67
Version 1.3
Doremi Cinema LLC Confidential
