•
Enter the "DLP Head IP" address and then click the “test” button
Note:
If user enables subtitles without the ShowVault being connected to a projector the server
will not operate properly.
•
Specify if this is the primary projector or not using the corresponding radio button
Note:
The "DLP Username and Password" are not used.
•
Check the “Enabled” check box at the top right corner of the GUI
•
Click the “Save” button to record these settings
•
A password confirmation page will appear, enter the password to save and record the
settings
5.1.2 Removing a Projector
•
To remove a projector click on its name on the left part of the "Device Manager" GUI
•
Click the “Delete” button (see Figure 22 above)
5.2 Automation Libraries Management
Support for theater automation control is also provided. The list of currently supported devices is
the following:
•
eCNA
•
JNior
A pre-built library of supported automation commands is available for each of these two devices.
These automation commands can then be added to Macro Cues as presented in Section
6.2
.
5.2.1 eCNA Device
5.2.1.1 eCNA Device Addition
•
To use the eCNA device click the “Add” button and select “eCNA”
•
Enter the eCNA device IP address in the appropriate field as presented below:
_____________________________________________________________________________________
SHV.OM.001293.DRM
Page 26
Version 1.3
Doremi Cinema LLC Confidential
