•
When prompted for a user name type
admin
and then press "Enter"
•
When prompted for a password type the "admin" password and then press "Enter"
•
Type:
bin
and then press "Enter"
•
Type:
cd ./etc/rc.once
and then press "Enter"
•
Type:
put dcp2000_patch-0.5.2-26.pkg
and then press "Enter"
•
When the transfer is completed type
bye
and then press "Enter"
Note:
These steps may vary depending on the FTP client and whether user is on a Linux or
Windows PC. The login information, file names, and destination folder are the same in
both cases.
10.4.2 Performing the Software Upgrade
•
To perform the upgrade of the ShowVault software simply reboot the unit
•
Login as "root" and from the terminal command prompt type:
reboot
and then press
"Enter"
•
Once the ShowVault has rebooted login again as "root"
•
Open a new terminal command and type:
halt
and then press "Enter"
•
This command will initiate the shutdown of the ShowVault unit
•
After approximately 20 seconds or so, the unit will shut off automatically
•
After the ShowVault has shutdown power it on and log in
•
This will complete the software update
10.4.3 Sending the Firmware File to the ShowVault
•
To send a new firmware file to the ShowVault JPEG-2000 decoder use a FTP client and
log in as follows:
•
Type:
ftp 192.168.100.50
and then press "Enter" (IP address of the ShowVault)
•
When prompted for a user name type
admin
and then press "Enter"
•
When prompted for a password type the "admin" password
•
Type:
bin
and press "Enter"
•
Type:
cd ./etc/rc.once
and then press "Enter"
•
Type:
put fw-1.53.pkg
and then press "Enter"
(fw-1.53.pkg is the upgrade file that is
received from Doremi)
_____________________________________________________________________________________
SHV.OM.001293.DRM
Page 66
Version 1.3
Doremi Cinema LLC Confidential
