OP000469
Operating Controls
2-8
1. Starter Switch
A four-position starter switch is used to start or shut
down engine for equipment operation.
O.
Turning the switch to this position turns the
engine "OFF" along with its electrical system. In
this position the engine is "OFF" but the interior
cabin light is functional.
I.
Turning the switch to this position turns the
engine electrical system "ON." The battery
warning light and the oil pressure indicator light
should be "ON".
Moving switch to this position will crank engine.
When engine starts, release key and allow it to
return to "I" (ON) position. Do not operate the
starter switch for more than fifteen seconds at a
time. This will help prevent damage to starter.
Preheat position. Used to aid engine starting in
cold weather. When key is in this position, engine
preheater is operating. When preheat indicator
light turns "ON" engine preheat cycle is complete.
Immediately turn key to crank position and start
engine. This light turns "ON" after fifteen seconds
when the starter switch is turned to the preheating
position.
2. Travel Speed Selector Switch
O.
In this position, "LOW" travel speed is selected.
I.
In this position, "HIGH" travel speed is selected.
FG001364
O
I
Figure 4
WARNING!
DO NOT USE STARTING FLUIDS. The preheat
system could cause the starting fluid to explode.
.
.
O
I
HDO2022I
Figure 5
WARNING!
Do not operate the travel speed selector switch
when unit is in motion. Temporary loss of control
could result.
Summary of Contents for DX35Z
