OP000471
Inspection, Maintenance and Adjustment
4-14
5.
If the level is below "L" mark add oil.
A.
Shut down engine.
B.
The hydraulic tank is pressurized. Turn the
breather cap slowly to allow the pressurized air to
vent.
C.
Remove the upper cover of the hydraulic tank and
add oil.
6.
If oil level is above the "H" mark drain oil.
A.
Swing upper structure perpendicular (90°) to
tracks as shown in (Figure 18).
B.
Shut down engine and wait for the hydraulic oil to
cool down.
C.
Remove the right bottom cover.
D.
Drain the excess oil from drain valve at the
bottom of the tank into a suitable container.
Check for Leaks in Hydraulic System
1.
Perform a daily walk-around inspection to make sure
that the hoses, piping, fittings, cylinders and hydraulic
motors are not showing any signs of leakage. If any is
noted, determine the source of the leak and repair.
Figure 17
FG007664
IMPORTANT
Do not fill above "H" mark on sight gauge.
Overfilling can result in damage to equipment and
oil leaking from hydraulic tank due to expansion.
Figure 18
FG007690
Summary of Contents for DX35Z
