OP000471
Inspection, Maintenance and Adjustment
4-42
2.
Place bucket, with wooden blocks under it, as shown in
illustration.
Move front edge of bucket up slightly to make work
easier, if desired. Do not raise it too far or the teeth
may cause injury if fallen on.
3.
Check tooth point and side cutter for wear or
looseness.
4.
Tighten tooth points and side cutters or replace if
damaged:
A.
Remove nuts (1), washers (2) and bolts (3).
Remove side cutters (4). (Each side cutter has
three sets of bolts and nuts.)
B.
Remove nuts (5) and bolts (6). Remove tooth
point. (A tooth point has two sets of bolts and
nuts)
C.
Reinstall parts in reverse order of disassembly.
D.
After the first operation following point
replacement, retighten nuts.
Figure 55
Summary of Contents for DX35Z
