Roto 512-83R
QUICK REFERENCE GUIDE
This Quick Reference Guide DOES NOT replace the Operators
Manual. You MUST read ALL the disclaimers and safety and other
instructions in the Operators Manual before initially operating this
product. Accordingly, no legal claims can be entertained based on
the data, illustrations or descriptions in this Quick Reference Guide.
Access additional information
Instrument Panel
Start Up Sequence
Static Dimensions
Tie Down Points
Cab Layout
A.
Instrument panel
B.
Multipurpose switch
C.
Ignition switch
D.
Console switches
E.
Heating and A/C controls
F.
Accelerator pedal
G.
Right hand joystick
H.
Outrigger control
J.
Switch panel
K.
Rotary switch control
L.
Slew lock lever
A. Display screen
B. Warning indicator
C. Tachometer
D. Navigation button down
E. Navigation button up
F. Fuel level gauge
G. Coolant temperature gauge
H. Information switch
A. Left front outrigger select
button
B. Right front outrigger select
button
C. Left rear outrigger select
button
D. Right rear outrigger select
button
E. Outriggers auto deploy and
level
F. Outriggers auto stow
G. Outriggers auto level select
button
H. Axle oscillation lock button
J.
Sway left select button
K. Sway right select button
L.
Control isolate button
M. Auto idle select button
Best Practices
1.
Carry a load as low as possible while maintaining good
visibility.
2.
Forks should be tilted back when in transport
–
with or
without a load, cradle the load.
3.
Fork tips should be on the ground when unit is parked.
4.
Rather than driving into the load, extend the boom to easier
see the forks in the load.
A
Overall Height ft-in
10-1
B
Overall width over the tires ft-in
8-1
C
Front Track ft-in
6-8
D
Wheelbase ft-in
10-0
E
Overall length to front tires ft-in
17-4
F
Overall length to front carriage ft-in
26-6
G
Ground Clearance ft-in
1-1
H
Front wheel center to carriage ft-in 11-1
J
Rear wheel center to rear face ft-in
5-5
K
Rear tail swing ft-in
10-5
L
Inside width if cab (between windows) ft-in
3-1
M Outriggers fully extended (not deployed) ft-in 18-6
M Outriggers fully extended (Fully deployed) ft-in 17-4
Machine Model 512-83R
M. Operator seat
N.
Left hand joystick
P.
Controls isolation lever
Q. Brake pedal
R.
Transmission and drive lever
S.
Steering wheel
T.
Face level fan
U.
Load management system
V.
Rapid recovery switch
W. Emergency recovery pump
X.
LMS override
A. Turn the key to position 1.
B. Allow the machine display to start up.
D. Display will ask for confirmation of the front attachment
E.
Accept by pushing the check mark button (behind the
joystick)
F.
Disarm the immobilizer by typing in the code and pressing
the check mark on the membrane pad.
G. Turn the key to start machine.
Immobilizer keypad
Attachment Confirmation Switch
1.
Move the machine onto the transport vehicle.
2.
Engage the slew lock.
3.
Secure the machine to the trailer with chains. The chain angle must
be within the permissible angular range specified.
4.
The correct tie down positions are identified on the machine by
their labels.
5.
Measure the maximum height of the machine from the ground.
