Docomo F-01A, Instruction Manual

Page: 62 / 519

60
Voice/Videophone Calls/PushTalk
◆
Using Voice clear/Voice slowing
❖
Switching Voice clear ON/OFF
Measure the noise level during a voice call, and if the noise increases above the
specified level, the other party's voice is automatically emphasized to be heard
clearly. And, the volume is automatically increased also when your or other party's
voice is low.
･
This function does not operate while using speakerphone function or in overseas
GSM/GPRS network.
･
The settings are retained after a call.
･
This function is not for adjusting Listen volume. Change the volume of the other
party's voice with Listen volume.
1
During a voice call,
m7
When setting to "ON", appears. When this does not operate with
ON, it is displayed in gray.
❖
Switching Voice slowing ON/OFF
During a voice call, adjust the other party's voice to be heard slowly by using the
silence at intervals, to make it easier to be heard. When the other party speaks
without intervals, the voice is heard at the normal speed.
･
If you set Voice slowing to ON, the quality of the other party's voice, music or time
tone may change. In this case, set Voice slowing to OFF.
･
This function does not operate in overseas GSM/GPRS network.
･
The settings are canceled after a call.
1
During a call,
a
When setting to "ON", appears. When this does not operate with
ON, it is displayed in gray.
Switching a voice/videophone call during a call
･
Switchable only from the caller.
･
This function is available among the models which support switching voice call
and videophone call.
･
To switch the call, the other party needs to set Notify switchable mode to ON. →
P74
<Example> Switching to videophone call during a voice call
1
During a voice call,
I e
"Yes"
･
During call switching, a message indicating to switch the call is played.
･
When switched to videophone call, speakerphone is activated.
Switching to voice call during a videophone call : During a videophone call,
m1 e
"Yes"
･
Speakerphone is deactivated when the call is switched to voice call.
✔
INFORMATION
･
It takes approximately 5 seconds to switch. It may take longer depending on radio wave
conditions.
･
Voice calls and videophone calls are charged individually depending on their
respective times. The time for switching calls is not counted in the call duration thus
not charged.
･
Under some radio wave conditions, switching calls is unavailable, resulting in
disconnection of the call.
･
During voice call using Call Waiting, switching to videophone call is unavailable.
･
When packet communications are made during a voice call, packet communications
are disconnected before switching to a videophone call.
･
While the other party is performing packet communication, switching to a videophone
call is unavailable.
･
Settings such as camera image sending etc., made during a videophone call are
canceled each time you switch voice call and videophone call.
→
P72