Digital Monitoring Products
XR200/XR2400F Programming Guide
16
5.7
Service Receiver Authorization
YES
enables remote commands and programming to be accepted from a secondary
service receiver other than the alarm SCS-1 Receiver. The Remote Key option can
also be required.
With
YES
selected, the panel requests the
service receiver key
the first time it is
contacted by the service receiver. The panel retains this
service receiver key
in
memory and accepts remote commands from the service receiver.
If an alarm occurs during a remote connect, the panel disconnects from the
service receiver and calls the alarm receiver. Alarm reports are only sent to the
alarm receiver. It is important that the
alarm receiver key
and the
service
receiver key
programmed at the central station are NOT the same so the panel
can determine the difference between receivers.
When
NO
is selected remote commands and programming are not accepted from a
secondary service receiver.
This option must be
YES
to allow programming from a directly connected
computer or an Ether-Com.
5.8
Remote Phone Number
Press COMMAND to enter the phone number the panel dials whenever remote
programming is requested. After entering a phone number, the panel allows
remote commands and programming only after it has first been called by the
authorized receiver, disconnected itself, and has redialed the remote phone
number.
If a Remote Phone Number is NOT entered, and Alarm Receiver and Service
Receiver is
YES
the panel allows remote commands and programming without
disconnecting and redialing. The phone number can be up to two lines of 16
characters to equal 32. Enter a
D
for dial tone detect and a
P
for a 3 second
pause.
Note:
When not in the Programming Menu, the function 984 + COMMAND can be
entered at the keypad, and a remote options menu appears. This menu contains
the following options:
NUMBER
- The panel allows you to enter into the keypad a phone number you
want the panel to dial. Enter any required prefixes and area codes.
REMOTE
- The panel dials the phone number programmed in Remote Phone
Number.
PICKUP
- The panel picks up the phone line as Remote Link™ calls in. The phone
must be ringing before selecting
PICKUP
.
5.9
Remote Disarm
YES
allows the panel to be disarmed remotely.
NO
disables remote disarming.
SVC RCVR NO
YES
DISARM
NO
YES
NBR RMT PICKUP
REMOTE PHONE NO
-
-
5 - REMOTE OPTIONS
