Digital Monitoring Products
XR200/XR2400F Programming Guide
10
3 - COMMUNICATION
3.3.1
Test Frequency
Specifies the communication test interval for the second phone line. This is
displayed if
2ND LINE
is programmed as
DD
,
CELL
or
HST
. The default Test
Frequency is
NONE
.
NONE
- No communication test is made on the second line.
REG
- A
2ND LINE
communication test is made each time the regular
communication test is completed.
7
- A communication test is made every 7 days at the test time programmed for
the regular communication test. Test time deferrals are disregarded.
30
- A communication test is made every 30 days at the test time programmed for
the regular communication test. Test time deferrals are disregarded.
If the
2ND LINE
test fails to communicate after 10 attempts, the regular
communication channel sends a WARNING: PANEL BACKUP COMMUNICATION FAIL
(S12) report. The next time the panel sends a report over the
2ND LINE
, the
regular communication channel sends a
BACKUP COMMUNICATION LINE RESTORED
(S04) report.
3.4
Account Number
Enter the account number sent to the SCS-1 Receiver.
DD
and
HST
- The range of valid account numbers for a panel using these
Communication Types is 1 to 65535. For accounts of four digits or less, do not
enter leading zeros. The panel automatically right justifies the account number.
CID
and
M2E
- Choose an account number between 1 to 9999.
MPX
- A 5-digit account number is required for panels using these formats. The
first digit is the receiver line number. The second digit is always zero. The last
three digits are the panel's account number. This number must be between the
range of 000 and 127. Individual area account numbers must be between the
range of 128 to 999 on the same line.
Example:
10128 to 10999.
3.5
Transmit Delay
Enter the length of time the panel waits before sending burglary reports to the
receiver. The available range is 1 to 60 seconds. Alarm bells and relay outputs
are not delayed during this period. Burglary Outputs in section 8 must be
programmed for pulsed or steady. Set Abort Reports in section 6 to
YES
if Opening
and Closing reports are not being sent.
Enter zero to disable Transmit Delay. The default Transmit Delay is
0
(zero).
3.6
DTMF
YES
enables tone dialing by the panel.
NO
enables rotary dialing.
3.7
Events Manager
Specifies when non-alarm reports are sent to the receiver. This selection does not
affect zone alarm, zone trouble, zone restoral, supervisory, or serviceman
messages. Closing reports are not delayed if the Closing Wait option is
YES
.
SND
- If send is selected, all reports are sent to the receiver as they occur.
DLY
- All non-alarm reports are held until the panel's memory buffer contains 133
events or until the panel's next communication with the receiver. Contact ID and
Modem IIe do not delay reports but send them as they occur.
KEEP
- All non-alarm reports are held in the panel's memory buffer until they are
overwritten by new activity. You can view the contents of the memory buffer
using DMP Remote Link™ or System Link™. You can also use the display events
feature in the User Menu. Refer to the Appendix for a table listing the delayed
report types. Contact ID and Modem IIe do not delay reports but send them as
they occur.
TEST FREQ:
NONE
NONE REG 7 30
DTMF NO
YES
EVENT MGR:
SEND
SND DLY KEEP
ACCT NO: 1 2 3 4 5
XMIT DELAY: 0
