dixell ichill IC260L, User Manual

Page: 49 / 105

1592015300 User manual iCHILL 200 L GB r1.3 09/09/2005
Pg.
48/105
14 DISPLAY LAYOUT
As default, In normal condition, the display shows the circuit 1 information.
The displayed circuit is indicated from the corresponding led
Cir1 on (UP key), or Cir2 (circuit 2, DOWN key).
14.1 H
OW TO SHOW THE MEASUREMENT LIST
.
With the led Cir1 on, push UP or Down keys to display the labels of the information of the circuit 1.
With the led Cir2 on, push UP or Down keys to display the labels of the information of the circuit 2.
Each measurement is defined by a label that indicates which if it is a pressure a temperature or a time.
14.2 S
HOW THE CIRCUIT
1
OR
2
To swap between the information of the two circuits use the UP and DOWN key to select a label then push SET, check the led.
Example in fig.1
Led cir1 is on:
the top display shows the value of the output evaporator temperature ( 7.8°C) of the circuit 1,
The bottom display shows Out 1. Push SET key to swap to the circuit 2. Fig2
Led cir2 is on: the top display shows the value of the output evaporator temperature ( 7.9°C) of the circuit 2, the bottom display shows
Out 2.
Fig.1
Fig.2
15 CUSTOM DISPLAY
The dP family of parameters allows to set a custom display read-out
. The user can change the default read-out (both
for instrument and remote terminals) of the measurements depending on the application.
Top Display
Bottom display
15.1 D
EFAULT READ
-
OUT OF THE TOP DISPLAY
To set the default value displayed on the top display:
1.
Set the parameter dP03 = 0, it means configurable;