Dish Network VQ4510, User Manual, Page: 165 / 181

6. Verify “Scan” is highlighted.
Press
SELECT on your remote.
5. Highlight the state you are currently in from the state menu.
Press
SELECT on your remote.
VQ4500 & VQ4510
Quick Reference Guide
11200 Hampshire Avenue South, Bloomington, MN 55438
PH 952.922.6889 || FAX 952.922.8424 || kingconnect.com
Automatic Satellite TV Antenna
Thank you for choosing a KING Antenna!
The KING Tailgater Automatic Satellite System is designed to work with both
VWDQGDUGDQGKLJKGH¿QLWLRQVDWHOOLWH79EURDGFDVWVIURP',6+VDWHOOLWHV
110/119/129, and ONLY ZLWKWKHIROORZLQJ',6+UHFHLYHUV
9L3 ® ]‡9L3N‡9L3‡
)RUVHFRQGUHFHLYHUXVHVHH\RXU2ZQHU¶V0DQXDO
,I\RXU5(&(,9(5LV
1(:$1'81$&7,9$7('
,
VHHWKHEDFNRIWKLVJXLGH¿UVW
For all things Tailgater,
VHH\RXU2ZQHU¶V0DQXDO
If the
Mobile Antenna Setup
screen does not display,
press 0(18 , 6 , 1 , 1 on your DISH remote.
Highlight “Check Switch.” Press
SELECT on your remote.
The
Mobile Antenna Setup
screen should now display.
Lay the unit on a soft,
non-scratching surface,
and apply the (3)
rubber feet.
4. Use the arrow buttons on your remote to highlight the letter group
WKDWLQFOXGHVWKH¿UVWOHWWHURIWKHVWDWH\RXDUHFXUUHQWO\LQ
Press
SELECT on your remote.
The scan will begin and may take up to a few minutes to complete.
This screen will display during the scan.
for DISH
®
DISH and Tailgater are registered trademarks of DISH Network L.L.C.
KING is a registered trademark of Electronic Controlled Systems, Inc.
21956 Rev A
2. Place KING Tailgater in position and make connections
in the following order: A , B , and C .
3
5
7. When the scan is complete, the
Acquiring Signal
message will
display. Acquiring the signal may take up to 5 minutes to complete.
6
8. After your receiver has acquired the signal, the electronic program
guide will download. This may take up to 5 minutes to complete
(potentially longer if an external hard drive is connected).
7
9. Choose a channel and watch TV. Enjoy!
8
$Q\WDOOREMHFWVFDQEORFNWKHVDWHOOLWHVLJQDO
'2127$33/<)((7
,)<28:,//%(522)
02817,1*7+(
$17(11$81,7
67$1'$5'23(5$7,21
)LUVW7LPH8VHUVVHHEDFN
1
B
A C
When you plug in the receiver, the green power light should illuminate or
begin cycling on and off (if not, check AC connection).
Wait for the green light to turn solid. This may take up to two minutes.
If it does not turn solid, power on your receiver using the front panel
POWER button. (On “z” models, this is located behind the door panel.)
4. Turn on your TV.
In your TV’s input
selection menu, choose
the input that matches the
connection from
your receiver.
The
Mobile Antenna Setup
screen should display.
3OXJLQ
UHFHLYHU
last!
'RQRWRYHUWLJKWHQFRD[FRQQHFWLRQV'RQRWSXOORQFRD[
2
If you get a box saying that not all satellites were acquired,
see the troubleshooting section in your Owner’s Manual.