Dish Network VQ4510, User Manual

Page: 73 / 181

Receiver Customization
63
Operating Other Devices
Programming to Control a Second Dish Antenna
If you have a second DISH antenna installed, you can use this remote in AUX mode to
operate your other receiver in addition to operating the first receiver. When you program
the remote to operate the other receiver, the remote sends out IR signals to the receiver
so the line of sight to the second dish antenna must be unobstructed. You can program the
remote control to operate any other DISH antenna, except where UHF is used, such as
TV2 on DISH antennas.
1
Turn on the other receiver and display the System Info screen as described in that user’s
guide.
Write down the remote control address:
2
Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
3
Press the 3 button.
4
Use the NUMBER PAD to enter the address you wrote in step 1.
5
Press POUND (#). AUX blinks three times.
6
Press RECORD to ensure the address in the remote matches the address on the
receiver.
1
2
3
4
5
6
Display System
Information
screen and note the
IR Remote Address
Press and hold the
AUX Mode button until all
Mode buttons light up
(Button will Flash)
Enter remote
address from
step one
Press the
3 button
Press
POUND
(AUX button
will flash 3 times)
Press
RECORD