Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 38 / 67

38
Operating instructions
•
DINO 160XTB
•
180XTB
•
210XTB
5.1.3. Starting up
1. Switch on the current using the mains switch
2. To access the operating controls open the cover behind the power unit
3. Turn the selector switch (1) to position 1b - chassis panel
4. Start the engine with button 2 (green)
If you wish to operate the support outriggers, start
the motor by pushing the green button on the
battery housing on the right-hand side. The motor
will run only as long as the button is kept
depressed. The motor starts and stops
automatically whenever the boom system or the
driving device is being operated.
5.1.4. Levelling the lift
1. Lower the front support outriggers 1 and 2 (on the tow-bar side).
2. Lower the rear support outriggers 3 and 4. (do not damage the tow-bar jockey wheel)
3. Level the chassis with the outriggers with the help of the level gauge (16). The air bubble
must be located inside the inner ring.
4. the signal light (4A, green) in the chassis control centre is illuminated, when all the
outriggers are in the support position and the limit switch circuit of the outriggers is closed
Before using the lift, check that:
• the cassis is level
• the wheels are clearly off the ground
• all outriggers are firmly supported on the ground
DANGER
WARNING
CAUTION
NOTICE
The operation is prohibited if the lift is not properly supported and in a level position.
observe the effect of ice, possible rain and inclination of the surface on the support
(the support outriggers must not slip on the surface.
DANGER
WARNING
CAUTION
NOTICE
If you have levelled the chassis of the lift ON A
GRADIENT, turn the boom around carefully in
the lower position to make sure that the boom
does not bang against the support outriggers
or other obstacles.