Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 59 / 67

59
8.1. DAILY MAINTENANCE TASKS
8.1.1. Condition of chassis, boom and work platform
Inspect visually the condition of access systems, work platform, platform gate and handrails.
Check that the chassis and boom have no visible signs of structural damage.
8.1.2. Check the tyres and tyre pressure
Inspect the condition of tyres visually and chack that they are not flat.
8.1.3. Check the lights
Check all the warning and signal lights and trailer lights for road traffic.
8.1.4. Check the hydraulic oil
Check the hydraulic oil level while the platform is in transport position. Add oil if needed.
160XT
180XT
210XT
The oil tank is located under a cover on the rights side of the device.
Chech that the oil visible from the oil meter looks clean and normal (no excess foam etc.)
8.1.5. Check the hydraulic hoses, pipes and connectors
Inspect the condition of hydraulic hoses, pipes and connections visually.
Make sure that there are no visible oil leaks.
Any externally damaged hoses or clashed pipes and connections must be changed.
8.1.6. Check the operation of safety limit switches
Test the correct operation of safety limit switches that prevent the boom and outrigger
movements unless the platform is in a correct position.
1. Platform must be in transport position, outriggers up and the driving device connected.
2. Lift the boom from lower controls.
The boom must not work in any position of the control device.
3. Drive the outriggers down to operating position
4. Lift the boom so that the boom is not on the support
5. Drive the outriggers.
The outriggers must not work in any position of the control device.