Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 31 / 67

31
Battery gauge (34)
1. As the current is switched on using the key switch, the operating hours
of the motor are displayed on the gauge for 5 seconds.
2. During normal operation, the state of charge of the batteries is
displayed in per cents.
3. If the motor controller observes malfunction, an error code is displayed.
The LED signal lights in the gauge indicate the current mode of the display.
Left LED green LED at the centre yellow Right LED red
ON - operating hours are
displayed
ON - state of charge of the batteries is
displayed in %
Flashes – state of charge below 10 %
Flashes - error code
Error codes
CODE DESCRIPTION REMEDY
11 Internal current measurement error in the controller Switch off the current and retry
12 Error in the internal safety circuit for the controller. Switch off the current and retry
13 Malfunction or short circuit of motor connections Check the power cables and wiring of the motor.
14 Locking/malfunction in the directional switch circuit Check fuses, control circuit for the controller and
wiring.
21 Motor revolutions adjusted to too high value Check joystick and wiring of the control circuit
22 Emergency reverse - not in operation Controller incorrectly programmed
23 Locking/malfunction in the revolution control circuit Check fuses, control circuit for the controller and
wiring.
24 Motor revolutions adjusted to too low value Check joystick and wiring of the control circuit
31
Excess current or short circuit in the main
contactor spool
Check the main contactor, replace as required
32 Tip of main contactor shorted out Check the main contactor, replace as required
33 Field coil of the engine broken - not in use Controller incorrectly programmed
34 Control circuit for the main contactor spool broken Check whether the connector for the main
contactor is loose
41 Low battery voltage < 17VDC Recharge the batteries immediately
42 Excess voltage > 30VDC Check operation of the battery charger
43 Temperature too high > 85
o
C or too low < -25
o
C Check ambient temperature
44 Locking/malfunction in the selector switch circuit
Check fuses, control circuit for the controller and
wiring.
Capacity of the batteries is affected by the operating temperature.
100 % is reached at the temperature of 30
o
C, at 0
o
C the capacity is 80 % of normal, at -20
o
C the capacity is 50 % of normal
DANGER
WARNING
CAUTION
NOTICE
Note! When the charger is connected to mains, the display immediately shows 100 % even
if the batteries are not fully charged. You can check the state of charge of the batteries
before charging.
Always keep the charger connected for a sufficiently long time irrespective of the readout on
the display! The recharger is equipped with overcharge protection.