Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 48 / 67

48
Operating instructions
•
DINO 160XTB
•
180XTB
•
210XTB
5.6. IN CASE OF EMERGENCY
5.6.1. When at risk of losing stability
Reduced stability can be caused by a fault in the lift, the wind or other lateral force, collapse
of the standing base or negligence in providing sufficient support. In most cases one sign of
reduced stability is the inclination of the lift.
1. If there is time, try to find out the reason for the reduced stability and the direction of its
effect. Warn other people on the work site using the alarm signal.
2. If possible, reduce the load from the platform in a safe manner.
3. Reduce the outreach to the side by retracting the telescopic boom using the emergency
descent system. Avoid abrupt movements.
4. Turn the boom away from the danger zone, i.e. to a position where the stability of the lift
is normal.
5. Lower the boom.
If the stability has been lost as a result of a fault in the lift, repair such a fault immediately.
Do not use the lift until the fault has been repaired and the condition of the lift
has been verified.
5.6.2. In case of overloading
1. If there is time, try to find out the reason for the reduced stability and the direction of its
effect. Warn other people on the work site using the alarm signal.
2. If possible, reduce the load from the platform in a safe manner.
3. Reduce the outreach to the side by retracting the telescopic boom using the emergency
descent system.
4. The green light becomes illuminated when the overload situation is reset. After this the
machine may be operated normally.
5.6.3. In case the power supply is interrupted
Operation:
The lift is equipped with an emergency descent
system with a manually operated pump. Seen
from the lower control centre, it is located
behind the side cover on the right-hand side.
The operating lever for the pump is fixed on the
inside of the cover.
Always check the condition of the emergency
descent system before putting the lift into
operation
NOTICE! Start by retracting the telescope
completely, continue by lowering the
articulated arms and finally turn the boom.
Kyltin numero 54.1360
Kyltin koko (mm) 110 x 110
Pohjan väri sininen
Tekstin (kuvion) väri valkoinen
Tekstin korkeus
Materiaali tarramuovi
Kiinnitystapa oma liima
Kiinnitysalusta maalattu teräslevy
Käyttöpaikka DINO 160XTB
Lisätietoja
“Emergency descent” teksti muutettu
symboliksi 7.1.2016 LKö