Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 43 / 67

43
5.3. TRANSPORT
The lift can be moved by towing or with the platforms driving device.
Moving the lift is only allowed in the transport position. No persons or other
additional load is allowed on the platform while transport.
5.3.1. Preparing the lift for transport
The lift must be in transport position.
Prepare the lift for transport as follows:
1. Retract the telescopic boom fully.
2. Check that the platform is perpendicular to the boom.
3. Lower the boom/platform onto the support on the tow-bar. The limit switch on the
transport support prevents the operation of the support outriggers if the platform is not
down
4. Close the cover of the platform control centre.
5. Turn the selector switch (1) to position ”chassis control centre LCB”.
6. Lift the support outriggers.
• first the rear support outriggers 3-4 (do not damage the rear lights)
• then the front support outriggers 1-2 (do not damage the jockey wheel)
7. Make sure that the covers are locked.
If you intend to tow the lift:
1. Apply the parking brake.
2. Make sure that the driving device is disconnected.
3. Turn the selector switch to position OFF and disconnect the lift from the power supply.