Dinolift DINO 210XTB II, Operating Instructions Manual

Page: 51 / 67

51
FAULT REMEDY
6. Outriggers do not move
Boom is not resting on the transport support. Drive the boom onto the transport support.
The selector switch is in the wrong position. Turn the selector switch to position 1b.
Limit switch on the boom support has not closed. Drive the boom onto the transport support.
7. Malfunctions of platform movements – only one of the movements can be operated
Lifting and lowering of the boom and the
extension of the telescope are not operational,
the red light is illuminated on the platform and
in the chassis control centre, and the buzzer is
audible.
The boom has been overloaded; retract the
telescope and retry the operation (automatic
reset).
10. None of the outriggers moves although the selector switch is in position LCB
The boom does not rest properly on the support. Check the boom support and the operation of the
RK3.
18. Driving device does not operate, although the selector switch is in position LCB
Boom is not resting on the transport support. Drive the boom onto the support.
24. Wheel brakes overheat
Parking brake not completely released. Release the parking brake completely.
25. Ball-coupling is not locked
Inner parts of the ball-coupling dirty. Clean and lubricate.
Tow-ball of the towing vehicle too large.
Measure the tow-ball. According to DIN74058
the diameter of the ball must be max. 50 mm and
min. 49,5 mm.
With all other problems, please take the platform to a qualified DINO-service.
To avoid problems:
• Follow all operating, maintenance and safety instructions
• Be careful in situations with a risk of damage to the lift
• Keep the lift clean and protect it against moisture