Dino lift DINO 185XTS, Operating Instructions Manual

Page: 28 / 121

28
3. Establish the reason why the energy supply was interrupted.
IN CASE OF MALFUNCTION, WHEN EVEN THE EMERGENCY DESCENT SYSTEM IS
NOT OPERATIONAL
1. If the emergency descent system does not operate, try to warn other personnel present
on the site or call for help so that the normal operation of the emergency descent
system can be resumed, for example, by changing the battery or by making the lift
operative by some other means so that the person on the platform can be lowered
safely down.
Always check the condition of the emergency descent system battery before putting the lift
into operation.
12. STARTING UP
12.1 Familiarise yourself with the machine and these instructions
Read these instructions carefully and check out the warning and
instruction decals affixed to the machine before starting the
operation.
12.2 Starting the engine
12.2.1 From the chassis control panel LCB
1. Familiarise yourself with the switches and lights mentioned in this chapter in point
“LCB – operating controls in the chassis panel – XTS”
2. Perform the daily inspection (see point “Daily inspection” (also called “Start-up
inspection”)).
3. (See point “Worksite inspection”.)
4. Make sure that the mains switch (BMS) is turned on, and that the emergency stop
buttons (S1 and S4) have been pulled up.
5. Turn the power switch Q1 to the left to position: LCB - Chassis control panel.
6. Wake the electric system by keeping the switch S23 (rabbit/tortoise) turned for about
2-3 seconds.

The signal light H20 “Electric system
active” will then be illuminated.