Dino lift DINO 185XTS, Operating Instructions Manual

Page: 29 / 121

29

If the engine is cold, the glowing will occur
automatically. The signal light for glowing
H9 will remain illuminated until glowing of
the engine is completed. As soon as the
light is switched off, the engine is ready to start.
7. Turn the start switch S6 to the right to the position Start and keep it in this position
until the engine starts. To switch off the engine, turn the switch S6 to the left.

Make sure that no signal light other than
the light H20 (Electric system active)
remains lit.
Note! If the engine is not running, and the movements are not actuated, the electric system
goes into sleep mode in about 30 minutes. Then it must be reactivated by using the switch
S23 anew.
12.2.2 From the platform control panel UCB
1. Familiarise yourself with the switches and lights mentioned in this chapter in: UCB –
operating controls in the platform panel – XTS
2. Perform the daily inspection (see point “Daily inspection (start-up inspection)).”
3. Perform the worksite inspection (see point “Worksite inspection”).
4. Make sure that the mains switch (BMS) is turned on, and that the emergency stop
buttons (S1 and S4) have been pulled up.
5. Turn the power switch Q1 in the LCB panel to the right to position: Platform control
panel. Take the keys with you, when you go to the UCB centre on the platform.
6. Wake the electric system by keeping the pedal depressed for about 2-3 seconds.

Then the Electric system active signal light H21 in the
UCB panel will be illuminated.

If the engine is cold, the glowing will take place
automatically. The signal light for glowing H10 will
remain illuminated until glowing of the engine is
completed. As soon as the light is switched off, the
engine is ready to start.
7. Turn the start switch S5 to the right, to position Start, and keep it in this position until
the engine starts. To switch off the engine, turn the switch S5 to the left.