Navigator 2.0 User Manual & Service Guide
N2-5000-07-001 Rev 7
-
19-
Revised 10/16/2018
www.Dilon.com
NOTE:
Approximately 3.5 hours are required to charge a completely drained battery. Having a
second, fully charged battery available while the first battery is in use, is recommended.
CAUTION:
Do not expose the charger or power supply to water or liquids; the case is not
sealed.
Do not open the charger or power supply case; no user-serviceable parts are inside.
Do not cover the fan exhaust or obstruct the airflow; this will cause overheating.
Place the charger in a cool spot, away from external heat sources.
4C. Cables
In addition to the Wireless Pilot Probe, the Navigator 2.0 may also be used with cabled probes. One
of the following two cables is used, depending on the wired probe selected.
4C-1. 3mm Diameter Cable (Part # PM-4000-20) and Gain Module (Part # PM-0400-40)
The 12mm Lymphatic Mapping Probe uses a cable that has two conductors and an outside diameter
of approximately 3mm. It also uses a Gain Module (pictured below), which connects the control unit
to the probe cable.
1. Connect the 3mm Diameter Cable to the probe, matching the red indicator dot on the probe
to the red indicator dot on the cable.
2.
Connect the other end of the 3mm Diameter Cable to the gain module, matching the red
indicator dot on the cable to the gain module
’s cable input port.
3. Connect the gain module to the control unit, matching the arrows on the gain module cable
connector to the arrow above the signal input port.
The gain module connector will
“click”
when it is seated properly.
Summary of Contents for Navigator 2.0
Page 4: ......