DEUTZ-FAHR AGROTRON 106 MK3, Workshop Manual

Page: 139 / 150

20-21
4. PARAMETERS
4.1 CONFIGURATION
Via the menu item "Parameters" in the menu bar, you get to the "Configuration" screen. The configuration procedure is as
follows:
• Scroll with keys "Next" and "Previous" to the page which contains the Parameter to be set (example: "AccPedal
(SWG1)up. ref" on page 10: Setpoint gen. calibration values).
• Click on the field "New value" and enter the necessary numerical value. This must be between the indicated minimum
and maximum.
• Click on "PC->ECU". All configuration data is transmitted to the ECU.
The data is now incorporated in the ECU and can be used for testing the engine setting. It is however lost upon shutting
off the supply voltage.
• Save data record with the key "Save in ECU" (old data is overwritten).
• For checking purposes the data can be read out and displayed with the key "ECU->PC".
• Following satisfactory engine run the data record can be saved with the "Save in file" key on the hard disc or on a dis-
kette.
Figure: Example of a choice of configuration parameters.
EXPLANATION OF THE FUNCTION SWITCH
ECU->PC: The configuration data is read from the ECU and is displayed.
PC->ECU: Updated configuration data is uploaded to the ECU. In order for the uploaded data to be permanent, you must
activate the "Save in ECU" switch for the ECU.
Open file: The configuration data is read and displayed from a hex file.
Save in file: The configuration data is saved in a hex file.
The engine number will be suggested as file name for storage on from SERDIA 2.5. This suggestion is not compulsive; other
file names may be chosen nevertheless.
Then confirm with OK. The file (i.e. the engine data record) is then saved under the name <Engine number> hex.
Save in ECU (applies for EMR only): The configuration data are permanently saved in the ECU. changes to the con-
figuration have to be reported!
SERDIA PARAMETERS