- 47 -
(2)
Replacement
of
engine
oil
①
Remove the engine oil drain plug and discharge oil completely.
It can be discharged easily when the engine is warm.
②
After engine oil is discharged, tighten the plug firmly.
③
Charge new engine oil from the oil filler until it reaches
the notched line of the "H" on the dipstick.
④
After engine oil is supplied, run the engine for a few minutes.
Check that oil is supplied to the level between H and L .
(3) Replacement of engine oil filter element
①
Ensure that the oil filter assembly is clean before the procedure
for removing the filter element is carried out.
②
Use a suitable container in order to drain the oil filter. Remove
the drain plug (2) and drain the oil. Check the O ring seal on the
drain plug. If necessary, replace the O ring seal.
③
Remove the filter bowl (1) and the filter element from the engine.
Discard the old filter element and the old O ring seal. Clean the
filter bowl.
④
Install the filter element into the filter bowl. Ensure that the insert
(3) on the oil filter aligns to the square (4) in the filter bowl.
[ NOTE ]
: Do not fill the oil filters with oil before installing them.
This oil would not be filtered and could be contaminat-ed.
Contaminated oil can cause accelerated wear to engine
components.
⑤
Install the O ring seal (5). Lubricate the threads on the filter bowl with
CV60889 Special Lubricant.
⑥
Install the filter bowl and the element. Tighten the filter bowl (1) to a
torque of 90 N-m (66 lb ft).
⑦
Install the drain plug (2) and tighten to 1.2 N-m (11 lb in).
Parts number of oil filter element:
Parts number
manufacture
Parts number of manufacture
Y06020 41265
Perkins
CH10929
Summary of Contents for DCA-600P
Page 55: ...53 6 TROUBLESHOOTING...
