![Denyo DCA-600P Instruction Manual Download Page 29](http://html1.mh-extra.com/html/denyo/dca-600p/dca-600p_instruction-manual_2485066029.webp)
- 27 -
CAUTION
Battery
• The battery acid is dilute sulfuric acid. Improper handling will cause unexpected burns.
• When the battery acid gets on your clothes or skin, wash it out with a large volume of
water immediately. If it gets in your eyes, wash with a large volume of water immediately
and consult your doctor.
• In the worst case, it will put out your eyes.
(5) Check battery acid level
Remove the battery acid plug(cap) and check the liquid
level (10-12 mm above the electrodes). Supply distilled
water if necessary.
(6) Check air cleaner service indicator
This engine may be equipped with a different service indicator.
This engine are equipped with a differential gauge for inlet air
pressure. The differential gauge for inlet air pressure displays
the difference in the pressure that is measured before the air
cleaner element and the pressure that is measured after the air
cleaner element. As the air cleaner element becomes dirty, the
pressure differential rises. If your engine is equipped with a different
type of service indicator, follow the OEM recommendations in order
to service the air cleaner service indicator.
The service indicator may be mounted on the air cleaner housing or
in a remote location.
Observe the service indicator. The air cleaner element should be
cleaned or the air cleaner element should be replaced when the
following condition occurs:
・
The red piston locks in the visible position.
(7) Drain water in fuel primary filter
1. Place a suitable container below the primary fuel filter assembly (1).
2. Remove the drain plug (2). Allow the fluid to drain into the container.
Check the O ring seal on the drain plug for damage. If necessary,
replace the O ring seal.
3. When clean fuel drains from the primary fuel filter install the drain
Plug. Tighten the drain plug to the following torque 1.2 N-m (11 lb in).
Dispose of the drained fluid correctly.
(8) Check for leak of water and oil
Check the machine for the trace of leak of oil or water.
If a leak is found, check the location of leak and stop it.
When the leak cannot be stopped, contact our service
factory.
Summary of Contents for DCA-600P
Page 55: ...53 6 TROUBLESHOOTING...