Denyo DCA-600P, Instruction Manual

Page: 21 / 58

- 19 -
1-4-3 Generator controls and indicators
9. Frequency meter
This meter indicates the frequency of the outputted voltage. Make sure that it reads
50Hz or 60Hz when running.
10. Ammeter (U, V, W)
This meter indicates the current going to the connected load. It must not exceed the
rated current.
11. Voltmeter (Include voltmeter change-over switch)
The voltmeter indicates the outputted line voltage.
12. Three-phase circuit breaker
The circuit breaker is a safety device interrupting the mains when an overload or a
short circuit occurs at the load side connected to the receptacles. It also serves
as a main switch for supplying energy from the generator to the load connected to the
output receptacles.
Do not use this circuit breaker to turn on or off the load.
When tripped, the breaker must be reset manually by switching it to OFF and then to
ON after eliminating the cause of the trouble.
13. Voltage regulator knob
The output voltage is controlled by a regulator with rotating knob. Turning clockwise
increases the voltage and vice versa.
14. Pilot lamp
The lamp will be turned on if a dynamo generates electricity.