Chapter 3 Element Function
|
ScrEdit Software User Manual
Revision Apr. 30th, 2007, 2007PDD23000002
3-17
Property Description of System Function Buttons
Contrast
Brightness
This button allows the user to
adjust HMI LCD contrast and
brightness settings. After pressing
this button, the user will get the
following pop-up window to adjust
HMI LCD contrast and brightness
settings. If the user presses “Set for
default Contrast” button, it will set
HMI LCD to the default settings.
Low Security
Using this button can set the user priority to the lowest (Level
0). This option makes the user priority level become the lowest
to protect control system parameter not to be modified when
the user exits the different screens. It can also avoid the
misoperation that may cause system error. (This function is
also provided for Goto screen button.)
System Menu
After pressing this button, HMI will be back to system menu
screen. The user can return to operation screen just by
activating “Run” function or startup HMI again.
Report List
This button has many functions. It can be used flexibly
depending on the properties of the “Report List” option (Please
refer to page 2-124 in Chapter 2 and the following description of
Report Device).
Trigger
Trigger Mode
The user can use this setting to trigger the designated controller address to be ON
before or after writing the setting value. Please note that this function can only
trigger the controller address to be ON. If the controller address needs to be
triggered again, the user should set the address to be OFF manually.
This option is provided in Report List button only. When the user selects a Report
List button, the user can set this option in the property table.
The Report Device window is shown as the figure above. The Report Device can
be SMC, USB flash drive, and Printer. Please note that USB flash drive and Printer
are provided in DOP-AE and DOP-AS series HMI only.
SMC
Output the history records and alarm data to SMC card.
USB Flash
Drive
Output the history records and alarm data to USB flash drive.
Report Device
Printer
HMI will check if Print Typesetting function is set or not first. If Print
Typesetting function is set already, the screen data will be output to
the printer directly. If HMI detects the Print Typesetting function is not
set yet, the Hard Copy function will be enabled.
User Security Level
Use this option to set the user priority for pressing this element. Only the priority
that is equal to or higher than the current setting can use this element.
InterLock Address
InterLock Level
When InterLock Address is set to be ON or OFF (this is determined by the property
of “InterLock Level”), this button can be enabled.
Before Execute Macro If this option is set, when the user presses the button, the system will execute the
command of this macro first and then perform the operation of this button. But, if
the state of the button is not triggered by pressing the button (via macro or external
signal), the command of this macro will not be executed.
Summary of Contents for AE80THTD
Page 1: ......
