Delta Electronics AE80THTD, User Manual

Page: 264 / 329

Chapter 4 Macro Function
|
ScrEdit Software User Manual
Revision Apr. 30th, 2007, 2007PDD23000002
4-43
„ Code–107: There is RET in Macro
This error message means that there is RET command in Macro. RET command should be used for
sub-macro to return program. It means that the program does not finish. If the program needs to be
finished in Macro, please use END, not RET.
„ HMI Macro Error Messages
The user can read error messages by macro. Once there is an error and the user execute’s a correct
command before reading error message, the error message will be overwritten. When executing each macro,
each Macro error message will not be influenced by another macro.
„ Code–10: GOTO Error
This message means that there is GOTO error in macro.
„ Code–11: Stack Overflow
This message means that stack in macro is full. That may be cause by using too many sub-macros or
execute different macros at the same time. This is to avoid insufficient memory.
„ Code–12: CALL Empty Sub-macro
This is CALL sub-macro error. The sub-macro that is called should not be an empty sub-macro. This
message is to avoid unexpected error.
„ Code–13: Data Read Error
This is data read error. Sometimes this may be caused by memory data error but most of the time is the
controller data read error.
„ Code–14: Data Write Error
This is data write error. Sometimes this may be caused by memory data error but most of the time is
the controller data write error.
„ Code–15: Divisor is 0
This error message means that the devisor is 0 when performing division operation.