Dell S6000-ON, Configuration Manual

Page: 580 / 1080

• Enabling SNMP Traps for Root Elections and Topology Changes
• Configuring Spanning Trees as Hitless
Enable Multiple Spanning Tree Globally
MSTP is not enabled by default. To enable MSTP globally, use the following commands.
When you enable MSTP, all physical, VLAN, and port-channel interfaces that are enabled and in Layer 2
mode are automatically part of the MSTI 0.
• Within an MSTI, only one path from any bridge to any other bridge is enabled.
• Bridges block a redundant path by disabling one of the link ports.
1. Enter PROTOCOL MSTP mode.
CONFIGURATION mode
protocol spanning-tree mstp
2. Enable MSTP.
PROTOCOL MSTP mode
no disable
Example of Verifying MSTP is Enabled
To verify that MSTP is enabled, use the
show config
command in PROTOCOL MSTP mode.
Dell(conf)#protocol spanning-tree mstp
Dell(config-mstp)#show config
!
protocol spanning-tree mstp
no disable
Dell#
Adding and Removing Interfaces
To add and remove interfaces, use the following commands.
To add an interface to the MSTP topology, configure it for Layer 2 and add it to a VLAN.
If you previously disabled MSTP on the interface using the
no spanning-tree 0
command, to enable
MSTP, use the following command.
•
spanning-tree 0
To remove an interface from the MSTP topology, use the
no spanning-tree 0
command.
Creating Multiple Spanning Tree Instances
To create multiple spanning tree instances, use the following command.
A single MSTI provides no more benefit than RSTP. To take full advantage of MSTP, create multiple MSTIs
and map VLANs to them.
• Create an MSTI.
PROTOCOL MSTP mode
msti
Specify the keyword
vlan
then the VLANs that you want to participate in the MSTI.
580
Multiple Spanning Tree Protocol (MSTP)