Dell S6000-ON, Configuration Manual

Page: 503 / 1080

• If a LAG moves to the Down state due to this feature, its members may still be in the Up state.
LACP Basic Configuration Example
The screenshots in this section are based on the following example topology. Two routers are named
ALPHA and BRAVO, and their hostname prompts reflect those names.
Figure 58. LACP Basic Configuration Example
Configure a LAG on ALPHA
The following example creates a LAG on ALPHA.
Example of Configuring a LAG
Alpha(conf)#interface port-channel 10
Alpha(conf-if-po-10)#no ip address
Alpha(conf-if-po-10)#switchport
Alpha(conf-if-po-10)#no shutdown
Alpha(conf-if-po-10)#show config
!
interface Port-channel 10
no ip address
switchport
no shutdown
!
Alpha(conf-if-po-10)#
Example of Viewing a LAG Port Configuration
The following example inspects a LAG port configuration on ALPHA.
Alpha#sh int TenGigabitEthernet 2/31/1
TenGigabitEthernet 2/31/1 is up, line protocol is up
Port is part of Port-channel 10
Hardware is Force10Eth, address is 00:01:e8:06:95:c0
Current address is 00:01:e8:06:95:c0
Interface Index is 109101113
Port will not be disabled on partial SFM failure
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 40000 Mbit, Mode full duplex, Slave
Flowcontrol rx on tx on
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 00:02:11
Link Aggregation Control Protocol (LACP)
503