Dell S6000-ON, Configuration Manual

Page: 453 / 1080

Configuring Telnet with IPv6
The Telnet client and server in Dell Networking OS supports IPv6 connections. You can establish a Telnet
session directly to the router using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection
from the router.
NOTE: Telnet to link local addresses is supported on the system.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet [vrf vrf-name ] ipv6 address
–
ipv6 address
: x:x:x:x::x
–
mask
: prefix length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where
each group is separated by a colon (:). Omitting zeros is accepted as described in
Addressing .
SNMP over IPv6
You can configure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive
SNMP notifications from a device running Dell Networking OS IPv6. The Dell Networking OS SNMP-
server commands for IPv6 have been extended to support IPv6. For more information regarding SNMP
commands, refer to the
SNMP and SYSLOG chapters in the Dell Networking OS Command Line Interface
Reference Guide .
•
snmp-server host
•
snmp-server user ipv6
•
snmp-server community ipv6
•
snmp-server community access-list-name ipv6
•
snmp-server group ipv6
•
snmp-server group access-list-name ipv6
Displaying IPv6 Information
View specific IPv6 configuration with the following commands.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Example of
show ipv6
Command Options
Dell#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries
fib IPv6 FIB Entries
interface IPv6 interface information
mbgproutes MBGP routing table
mld MLD information
mroute IPv6 multicast-routing table
neighbors IPv6 neighbor information
ospf OSPF information
IPv6 Routing
453