Dell PowerEdge HX574, Hardware Owner'S Manual

Page: 119 / 202

Installing System Components
119
NOTICE:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
7
Install the new system battery.
a
Support the battery connector by pressing down firmly on the positive
side of the connector.
b
Hold the battery with the "+" facing up, and slide it under the
securing tabs at the positive side of the connector.
c
Press the battery straight down into the connector until it snaps into
place.
8
Replace the cooling shroud assembly. See "Replacing the Cooling Shroud
Assembly" on page 72.
9
Replace the PEM. See "Replacing the PEM or PEM Shell" on page 78.
10
Close the system. See "Closing the System" on page 68.
11
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
12
Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program" on page 45.
13
Enter the correct time and date in the System Setup program's Time and
Date fields.
14
Exit the System Setup program.
15
To test the newly installed battery, turn off the system and disconnect it
from the electrical outlet for at least an hour.
16
After an hour, reconnect the system to its electrical outlet and turn it on.
17
Enter the System Setup program and if the time and date are still
incorrect, see "Getting Help" on page 181 for instructions on obtaining
technical assistance.
Control Panel Assembly
Removing the Control Panel
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and