Dell POWER EDGE 2900, Hardware Owner'S Manual

Page: 20 / 182

20
About Your System
E1410 CPU # IERR
Specified microprocessor is
reporting a system error. See your system’s Information
Update Tech Sheet located on
support.dell.com for the most
current system information. If the
problem persists, see "Getting
Help" on page 147.
E1414 CPU # Thermtrip
Specified microprocessor is out of
acceptable temperature range and
has halted operation. See "Troubleshooting System
Cooling Problems" on page 123.
If the problem persists, ensure
that the microprocessor heat
sinks are properly installed. See
"Troubleshooting the
Microprocessors" on page 133.
NOTE:
The LCD continues to
display this message until the
system’s power cord is
disconnected and reconnected to
the AC power source, or the SEL is
cleared using either Server
Assistant or the BMC Management
Utility. See the
Dell OpenManage
Baseboard Management
Controller User’s Guide
for
information about these utilities.
E1418 CPU # Presence
Specified processor is missing or
bad, and the system is in an
unsupported configuration See "Troubleshooting the
Microprocessors" on page 133.
E141C CPU Mismatch
Processors are in a configuration
unsupported by Dell. Ensure that your processors
match and conform to the type
described in the Microprocessor
Technical Specifications outlined
in your system’s
Getting Started
Guide
.
E141F CPU Protocol
The system BIOS has reported a
processor protocol error. See "Getting Help" on page 147.
E1420 CPU Bus PERR
The system BIOS has reported a
processor bus parity error. See "Getting Help" on page 147.
E1421 CPU Init
The system BIOS has reported a
processor initialization error. See "Getting Help" on page 147.
Table 1-6. LCD Status Messages (continued)
Code Text Causes Corrective Actions