To enter the host FC interface command mode for the specified vHBA, enter the following commands
through SSH to CIMC IP address:
Server#
scope chassis
Server /chassis #
scope adapter index
Server /chassis/adapter #
scope host-fc-if {fc0 | fc1 |
name
}
From FC interface command mode, you can enter the following commands:
Command
Description
set wwnn wwnn
Unique World Wide Node Name (WWNN) for the adapter in the form
hh:hh:hh:hh:hh:hh:hh:hh.
set wwpn wwpn
Unique World Wide Port Name (WWPN) for the adapter in the form
hh:hh:hh:hh:hh:hh:hh:hh.
set boot {disable | enable}
Enables or disables FC SAN boot. The default is disabled.
set persistent-lun-binding
{disable | enable}
Enables or disables persistent LUN binding. The default is disabled.
set mac-addr mac-addr
MAC address for the vHBA.
set vlan {none | vlan-id}
Default VLAN for this vHBA. Valid VLAN numbers are 1 to 4094. The default is none.
set cos cos-value
Class of service (CoS) value to be marked on received packets unless the vHBA is
configured to trust host CoS. Valid CoS values are 0 to 6; the default is 0. Higher
values indicate more important traffic.
set rate-limit {off | rate}
Maximum data rate for the vHBA. The range is 1 to 10000 Mbps; the default is off.
set order {any | 0-99}
Relative order of this device for PCIe bus device number assignment; the default is
any.
set error-detect-timeout
msec
Error detect timeout value
(EDTOV), which is the number of milliseconds to wait before the system assumes
that an error has occurred. The range is 1000 to 100000; the default is 2000
milliseconds.
set resource-allocation-
timeout msec
Resource allocation timeout value (RATOV), the number of milliseconds to wait
before the system assumes that a resource cannot be properly allocated. The range
is 5000 to 100000; the default is 10000 milliseconds.
set max-field-size size
Maximum size of the Fibre Channel frame payload (in bytes) that the vHBA supports.
The range is 1 to 2112; the default is 2112 bytes.
To enter FC error recovery mode, enter the
scope error-recovery
command from FC interface command
mode. From FC error recovery mode, you can enter the following commands:
Command
Description
set fcp-error-recovery
{disable | enable}
Enables or disables FCP Error Recovery. The default is disabled.
set link-down-timeout
msec
Link down timeout value, the number of milliseconds the uplink port should be offline
before it informs the system that the uplink port is down and fabric connectivity has
been lost. The range is 0 to 240000; the default is 30000 milliseconds.
51
|
Managing networking resources
