Results
Reboot the server to create the vHBA. If configuration changes are required, configure the new vHBA.
For more information about Cisco UCS VIC 1225 vHBAs, see the
Cisco UCS C-Series Servers Integrated
Management Controller CLI Configuration Guide, Release 1.4
. .
Related information
Modifying virtual HBA properties
(see page 50)
Viewing virtual HBA properties
Use the
show host-fc-if [fc0 | fc1] [detail]
command to display the properties of a single
vHBA, if specified, or all vHBAs.
The following example displays the properties of both vHBAs in summary mode:
Server /chassis # scope adapter 1
Server /chassis/adapter # show host-fc-if
Name World Wide Port Name FC SAN Boot Uplink Port
-------- ------------------------ ----------- -----------
fc0 20:00:00:22:BD:D6:5C:35 Disabled 0
fc1 20:00:00:22:BD:D6:5C:36 Disabled 1
The following example displays the properties of a specified vHBA in detail:
Server /chassis # scope adapter 1
Server /chassis/adapter # show host-fc-if fc0 detail
Name fc0:
World Wide Node Name: 10:00:00:22:BD:D6:5C:35
World Wide Port Name: 20:00:00:22:BD:D6:5C:35
FC SAN Boot: Disabled
Persistent LUN Binding: Disabled
Uplink Port: 0
MAC Address: 00:22:BD:D6:5C:35
CoS: 3
VLAN: NONE
Rate Limiting: OFF
PCIe Device Order: ANY
EDTOV: 2000
RATOV: 10000
Maximum Data Field Size: 2112
Modifying virtual HBA properties
To modify vHBA properties, log on to the switch with administrator privileges. You can use the following
commands to modify the properties.
For more information about Cisco UCS VIC 1225 vHBAs, see the
Cisco UCS C-Series Servers Integrated
Management Controller CLI Configuration Guide, Release 1.4
.
Managing networking resources
|
50
