3. Configure three digital input functions. (
Functions > CustomLogic > CustomLogic digital input
)
a. After configuration
CustomLogic digital input
changes to
Terminal(s) x, y, Slot #
, where x, y, and # represent the
terminal and hardware slot.
4. Select
Write
from the right side panel.
Create the logic
1.
Go to
Configure > CustomLogic > Logic creator
and create a
New
Project
with one
Section
and one
Block
.
2.
Add a
Rising edge contact
, a
Timer
, a
Rising edge contact
, a
Normally closed contact
and a
Set coil
. Connect the elements to each other on the logic grid as shown in the diagram below.
PPM 300 PICUS manual 4189341080 UK
www.deif.com
Page 132 of 213
