3. Select
Write
from the right side panel.
Create the logic
Controller 1:
1. Connect to controller 1.
2. Go to
Configure > CustomLogic > Logic creator
and create a
New
Project
with one
Section
and one
Block
.
3. Add a
Normally open contact
and a
Normally open coil
to the logic grid and connect them to each other.
4. Select the
normally open contact
.
a. Set the function to
Mode > Inputs > Under switchboard control
.
b. Select
Save
from the
Functions
menu.
5. Select the
normally open coil
.
a. Set the function to
ICC > Outputs > Inter-Controller Communication Out 1
.
PPM 300 PICUS manual 4189341080 UK
www.deif.com
Page 135 of 213
