No.
Item
Notes
6.
Broadcast
Broadcast
the single-line diagram to selected controller(s) connected
to PICUS.
A red dot
indicates changes have been made that are not yet
broadcast.
7.
Refresh
Refresh
to read the single-line diagram from the controller.
8.
New
New
resets and clears the single-line diagram to the factory default
for the connected controller.
CAUTION
This clears ALL the components from the diagram.
6.3 Tasks
6.3.1 Configure the single-line diagram
Configure the single-line diagram under
Configure > Single-line
.
INFO
Modifications within PICUS are not automatically written to the controller(s). These modifications need to be
broadcast to the controller(s) after you have drawn your diagram.
6.3.2 Add a component
1. To add a component, select and drag the required component from the
Components
panel on to the diagram in the
necessary position.
• A valid position on the diagram is shown with a green dashed line
.
◦ The component can be added in this position.
• An invalid position on the diagram is shown with a red dashed line
.
◦ The component cannot be added in this position.
◦ The
Info
area shows the reason the component cannot be positioned here.
2. Position the component as required on the single-line diagram.
3. You can now configure the component.
PPM 300 PICUS manual 4189341080 UK
www.deif.com
Page 61 of 213